JDC Titanium License Plate Mounting Kit
The JDC titanium license plate mounting kit allows you to swap out your old, rusty bolts with beautiful titanium! The kit is available in three options. Make sure to check your factory hardware for the correct replacement before ordering. Some cars will have a self-tapping screw with larger threads, and some will be a tighter M6x1.0 thread.
Options are below:
Bolts & Washers:
- (2) M6x1.0x20mm custom head bolts
- (2) Custom flush mounting washers (2 outer diameter sizes available)
(Made to thread into your existing license plate holes. Check for proper thread pitch before ordering.)
Bolts/Nuts/Washers:
- (2) M6x1.0x20mm custom head bolts
- (2) Custom flush mounting washers (2 outer diameter sizes available)
- (2) Two small washers for the back
- (2) Nylon locking nuts.
(This kit would be for use on cars that don't have a normal M6x1.0 thread pitch or any threads at all.)
Self-Tapping Screws/Washers:
- (2) M5x17mm or M6x17mm Custom head self-tapping screws
- (2) M6 Custom flush mounting washers (2 outer diameter sizes available)
(For cars that have coarse-thread screws.)
About our titanium:
JDC titanium hardware is made from Ti6Al-4V (Grade 5) titanium. These pieces will allow you to replace your ugly stock hardware with beautiful titanium that will outlast your car itself! Titanium is around 45% lighter, way stronger, and will not corrode like your stock steel bolts.
For a color chart and information on our titanium products please click here.
Shipping Times:
-
All JDC titanium products are made to order unless otherwise stated on the item listing. Please see the red banner at the top of the website for the current estimated turnaround time. Production time can vary depending on your order size, products ordered, and the difficulty of custom options requested.
